Campbell CR300 series - 4.1.2 Overview

CR300-Series Datalogger
12
Wire sensors with power
disconnected. To open a terminal on
the CR300, use the included flat-
blade screwdriver. Insert the wire,
taking care to clamp the terminal on
the conductor itself, not the
insulation.
Click Next.
The Outputs page displays the
Selected Sensors list to the left and
data storage tables to the right under
Selected Outputs. Two output
tables (Table1 and Table2 tabs) are
initially available.
Disconnect the USB cable. Attach the thermocouple to the CR300 as shown in Wiring Diagram.
Only one table is needed for this tutorial, so Table 2 can be removed. Click the Table2 tab, then click Delete Table.
Change the Table Name of the remaining table from Table1 to OneMin. Change the Store Every interval to 1
Minutes.