7) Indicator Lamps
vmr2006-083-011_b
1. Reverselamp(RED)
2. Neutral lamp (GREEN)
3. Engine temperature (RED)
Engine Temperature (RED)
This light turns on when
the ignition switch is turned
ON and remains on for
approximately 1 second.
When this indicator light is
ON, it indicates the engine is
overheating.
If engine overheats, refer
to ENGINE OVERHEAT in
SPECIAL PROCEDURES.
CAUTION: If the light does not turn
off right after engine starting, stop
engine. See an authorized Can-Am
dealer. Do not use the vehicle until
repaired.
Reverse Lamp (RED)
Indicates the transmission is in
reverse position.
Neutral Lamp (GREEN)
Indicates the transmission is in
neutral position.
8) Ignition Switch
Key-operated, 2-position switch.
vmr2006-083-011_c
TYPICAL — IGNITION SWITCH POSITIONS
1. Ignition switch
2. OFF
3. ON with lights
Insert key in switch and turn to ON
position. To remove key, turn key to
OFF position then pull it out.
Remember that having the lights on
without the engine running discharges
the battery. Always turn ignition to
OFF position after engine has been
stopped.
NOTE: While engine can be stopped
by turning ignition key to OFF posi-
tion, we recommend the engine be
stopped by the engine stop switch.
9) Fuel Tank Cap
CAUTION: Never place anything
over fuel tank cap because the vent
hole on the top of fuel tank cap can
be blocked and the engine could
misfire.
Unscrew counterclockwise and re-
move cap to allow fuel tank filling then
fully tighten clockwise.
NOTE: Ensure that vent tube is prop-
erly installed.
_____________________
69
To Next Page
Loading...
Need help?
General
