Candy CST 362L-S - Control Panel Functions; Door Operation and Safety; Start, Pause, and Cancel Functions; Delayed Start Functionality

!
EN
99
! Press the START/PAUSE button to start
the selected cycle.
! Once a programme is selected the
programme selector remains stationary on
the selected programme till cycle ends.
! Switch off the washing machine by
turning the selector to OFF.
! Press to start the selected cycle
(according to the selected cycle one of
the wash stage indicator lights will
illuminate).
ADD OR REMOVE ITEMS AFTER THE
PROGRAMMES HAS STARTED (PAUSE)
! Press and hold the START/PAUSE
button for about 2 seconds (some
indicator lights will flash, showing that the
machine has been paused).
! Wait 2 minutes until the safety device
unlocks the door.
! After you have added or removed items,
close the door and press the
START/PAUSE button (the programme
will start from where it left off).
CANCELLING THE PROGRAMME
! To cancel the programme, set the
selector to the OFF position.
! Appliance start time can be set with this
button, delaying the start by 3, 6 or 9
hours.
! Proceed as follows to set a delayed start:
- Select a programme.
- Wait until the indicator lights related to
temperature and spin of the programme
selected light up.
- Press the delay start button (each time
the button is pressed the start will be
delayed by 3, 6 or 9 hours respectively
and the corresponding time indicator
light will blink).
Opening the door
A special safety device prevents the
door from being opened immediately
after the end of the cycle.
Wait for 2 minutes after the wash
cycle has finished and the "Door
Security" light has gone out before
opening the door.
PROGRAMME selector with OFF
position
When you select a programme the
indicator lights related to temperature
and spin of that cycle will light up.
N.B.: To switch the machine off, turn the
programme selector to the OFF
position.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
Before you open the door, please
check water level is below the door
opening to avoid flooding.
DELAY START button