1) Move the command dial to a position other
than “ H ”,
2) Open the back cover by sliding the back
cover latch down.
3) Insert the film cartridge with the flat end
facing up and the bottom end entering the
camera first.
4) While holding down the film cartridge,
carefully pull the film tip across until it
reaches the orange mark.
5) After checking that the film lies flat and that
the tip is aligned with the orange mark,
close the back cover.
• The film automatically advances to the
first frame, the frame counter shows “1 ”
and the film cartridge symbol ( @ ) is
displayed in the LCD panel.
• If the film cartridge symbol blinks, the film
is not loaded correctly. Reload the film. If
the film is not loaded correctly, the shutter
will not release when the shutter button is
pressed.
13
To Next Page
