1) Press the function button so that “ <g> ”
appears in the LCD panel.
2) Turn the main dial to select “1 ” or “0” in the
LCD panel.
1: Red-eye reduction on. <s> is displayed
in the LCD panel.
0: Red-eye reduction off. <S> is not dis
played in the LCD panel.
• A lens hood attached to the lens will block
light from the built-in flash. Always remove
the lens hood when using the built-in flash.
• The bullt-ln flash and an external flash
cannot be used together.
• The bullt-ln flash will not operate when an
external flash unit or cover is attached to
the accessory shoe.
• If the built-in flash is held down while the
flash button is pressed, >03 will blink in
the LCD panel and the camera will stop
operating. This is not a malfunction. Press
the shutter button halfway to resume nor
mal operation.
37
To Next Page
Loading...
