* The bracketing amount is aiso dis
played in the viewfinder.
3) Set the command dial to the desired
shooting mode and take pictures.
• To cancel auto exposure bracketing, re
peat steps 1 and 2 to reset the bracketing
amount to 0.
• Auto exposure bracketing is automatically
canceled when the battery is replaced.
• Auto exposure bracketing cannot be used
in bulb mode or when using flash.
• Auto exposure bracketing can be used in
X mode or manual mode with flash units
connected through the PC terminal.
• The exposure level blinks in the LCD
panel and viewfinder display during auto
exposure bracketing operation.
If you wish to shift the bracketed exposure
values toward over- or underexposure, you
can add exposure compensation using the
quick control dial. In this case the LCD panel
may not display the correct values, but expo
sures will be made correctly.
To Next Page
Loading...
