P: Program AE
• Ifthe
"30""
shutter
speed
and the maximum aperture
blink, it indicates underexposure.
Increase the
ISO
speed
or
use flash.
• If
the
"8000" shutter speed and the minimum aperture
blink, it indicates overexposure.
Lower
the
ISO speed
or
use an NO filter (sold
separately) to reduce
the
amount
of
light entering the
lens.
7 I
~
~
I
t.
aJ
Differences Between
<P>
and<O>
(Full Auto)
With
<0>,
many functions such the AF
mode,drive
mode, and built-in
flash are
set
automatically to prevent spoiled shots. The functions
you
can
set are limited. With
<P>,
only the shutter speed and aperture are set
automatically. You can freely set the
AF
mode, drive mode, built-in flash,
and other functions.
About Program Shitt
•
In
the Program AE mode, you can freely change the shutter speed and
aperture combination (Program) set
by
the camera while maintaining the
same exposure.
T~lis
is called Program shift. •
•
To
do
this, press the shutter button down halfway, then turn the <
~
>
dial until the desired shutter speed
or
aperture value is displayed.
• Program shift is canceled automatically after the picture is taken.
• Program shift cannot be used with flash.
93
To Next Page
Loading...
