Introduction
V
The terms and expressions used in this manual are defined as follows:
1. Transmission Level (ATT): No.07 of Service Soft Switch #2 MENU
Increase the transmission level:
Increase the setting so that it is closer to 0 dBm. (At 0 dBm, the LCD indicates '0'.) Some
models, however, do not allow the setting to be increased to 0 dBm.
Decrease the transmission level:
Decrease the setting so that it is closer to -15 dBm. (At -15 dBm, the LCD indicates '15'.)
2. NL Equalizer: No.05 of Service Soft Switch #2 MENU
Adjust the NL equalizer:
Select 'ON'.
3. Transmission Page Timer: SW12 of Service Soft Switch #1 SSSW
Increase the page timer setting:
To set both transmission and reception to the same time-out length, set SW12 as follows:
8 min: bit 7, bit 1, bit 0 = 0, 0, 0
16 min: bit 7, bit 1, bit 0 = 0, 0, 1
32 min: bit 7, bit 1, bit 0 = 0, 1, 0
64 min: bit 7, bit 1, bit 0 = 0, 1, 1
If you want to set transmission and reception to different time-out lengths, or use different
time-out lengths according to different image modes, you will have to set all bits (from 7
through 0) accordingly. For details, see the G3 Facsimile Service Data Handbook.
4. T0 Timer: No.10 of Service Soft Switch #3 NUMERIC param.
Increase the T0 timer setting:
Increase the setting of No.10.
The T0 timer is used to set the period of time in which a line connection is recognized for
transmission, i.e., in which the machine waits for a significant signal from the other party after
dialing. The line will be disconnected if no significant signal is received during the period.
5. T1 Timer: No.11 of Service Soft Switch #3 NUMERIC param.
Increase the T1 timer setting:
Increase the setting of No.11.
The T1 timer is used to set the period of time in which a line connection is recognized for
reception, i.e., in which the machine waits for a significant signal from the other party after
transmission of DIS. The line will be disconnected if no significant signal is received during
the period.
DEFINITIONS OF THE TERMS AND EXPRESSIONS
To Next Page
Loading...
