Could not connect. The maximum number of devices that can connect to the
access point has been reached./Could not connect. Max no. of devices that
can connect to access point reached
The machine attempted to connect to a wireless LAN router to which the maximum number of devices
were already connected.
● Decrease the number of devices (clients) that are connected to the wireless LAN router. For information on
the maximum number of devices that can connect, see the instruction manual for the wireless LAN router
or contact the manufacturer.
Could not connect using the wireless LAN. Turn the main power OFF and ON,
then congure the settings again.
A connection failed due to an error while setting wireless LAN connection.
● Restart the machine and set again.
● If the problem persists even after restarting the machine, check whether the machine is properly installed
and ready to connect to the network.
Installation/Settings Problems(P. 452)
● If the problem persists even after checking the wireless LAN connection, check the security settings of the
wireless router.
Could not connect using WPS. Wait a moment, then congure the settings
again.
When automatic setting with WPS was attempted, the connection failed due to an error.
● Wait for a while, and set again. If the problem persists, check whether the wireless router supports WPS.
If WPS is supported:
Check whether the machine is properly installed and ready to connect to the network.
Installation/Settings Problems(P. 452)
If WPS is not supported:
Set using another connecting method.
Connecting to a Wireless LAN(P. 27)
Could not detect any connections from wireless devices.
Mobile device detection was not possible within the predetermined length of time.
● Connect again paying attention to the time limit.
Connecting Directly (Access Point Mode)(P. 202)
Troubleshooting
480
To Next Page
Loading...
