Canon imageCLASS MF4570dn - Set the fax receive mode

8
2.
Set the fax receive mode.
<Auto> mode is set.
→ Proceed to Step 3.
• Receives a fax automatically.
• Does not use the telephone.*
* If connecting with the telephone in auto receive mode, the telephone
rings when receiving a fax or telephone call. You can answer the
telephone while the telephone is ringing. To configure so that the
telephone does not ring, see “Incoming Ring” in the
e-Manual.
Do you want to use
this machine for fax
only (no telephone)?
Yes
No
Do you want to auto-
receive faxes and
answer phone manually?
Yes
No
Do you want to use
an answering machine
to answer the phone?
Yes
No
<Fax/Tel Auto Switch> mode is set.
→ Proceed to Step 3.
• Receives a fax automatically.*
• Responds to a telephone call by picking up the
handset.
* An incoming call rings. To configure so that the incoming call does not
ring, see “Incoming Ring” in the
e-Manual.
<Answer> mode is set.
→ Proceed to Step 3.
• Receives a fax automatically.
• Responds to a telephone call with the built-in
answering machine.
• Rings when receiving a call or fax.
<Manual> mode is set.
→ Proceed to Step 3.
• Responds to both a telephone call and fax with
handset pickup.
• Rings when receiving a call or fax.
You can specify how the machine should operate for a fax call or telephone call.
By answering the prompts that appear on the display, the machine will be set to one of the following four operation modes.
<Auto><Fax/Tel Auto Switch><Answer><Manual>
* You can set a receive mode other than the above manually depending on your country or region. For details on the setting procedure, see “Receiving Faxes” in the e-Manual.
Yes
Yes
Yes
No
No
No
Preface
1
Installing the Machine
2
Configuring and Connecting the Fax
3
Connecting to a Computer and
Installing the Drivers
4
Appendix