17
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Perform the following steps to set up the CR-190i. Refer to the section
for each step for details about that step.
A Check your operating environment. (See “Checking Your
Operating Environment,” on p. 18.)
B Install the software. (See “Installing the Software,” on
p. 19.)
Install the Scanning Utility provided with the CR-190i.
C Connect the scanner to a computer. (See “Connecting
the Scanner to a Computer,” on p. 20.)
D Turn ON the power. (See “Turning ON the Power,” on
p. 21.)
E Automatically installing the device driver. (See p. 22.)
The device driver is installed automatically when Windows
recognizes the CR-190i.
IMPORTANT
• To have the device drivers installed automatically when the computer
recognizes the CR-190i, the software needs to be installed before the
CR-190i is connected to the computer.
• If you connect the computer and turn ON the CR-190i before installing the
software, the following wizard screen appears. If this happens, click
[Cancel], turn OFF the CR-190i, and then install the software.
The following wizard screen is an example in Windows Vista. When a
similar wizard screen appears in Windows XP/7, click [Cancel].
Setting Up the Scanner
Wizard Screen (Windows Vista)
To Next Page
Loading...
Need help?
General
