2. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
3. Press the OK button.
The Set./Adj. Menu is displayed.
4. Press â–² or â–¼ to select Adjust Printer, and then press the OK button.
5. Press â–² or â–¼ to select Adj Far Ed Feed, and then press the OK button.
6. Press â–² or â–¼ to select Yes, and then press the OK button.
A test pattern is printed for adjustment.
C1 is displayed on the Control Panel.
7. Examine test pattern C1. Determine the pattern in which banding is least noticeable. Press â–² or â–¼ to select this
pattern number, and then press the OK button.
C2 is displayed on the Control Panel.
8. Examine test pattern C2. Again, determine the pattern in which banding is least noticeable. Press â–² or â–¼ to select
this pattern number, and then press the OK button.
The adjustment value is now registered, and adjustment is complete.
Note
• If streaks seem least noticeable in two patterns but you cannot decide which one is better, choose an
intermediate value. For example, choose 17 if you cannot decide whether pattern 16 or 18 is better.
Adjustments for Better Print Quality
>
Adjusting the feed amount
>
iPF6300 Adjusting Color on the Trailing Edge of Sheets
7
779
To Next Page
Loading...
Need help?
General