30
Q & A
Q1. HOW DO I ADD CUSTOM PAPER TO WORK WITH?
A1. Use the following procedure.
1. Add the new custom paper and calibration target to the printer with spectrophotometer
unit mounted by following the procedure in "2. ADD THE CUSTOM PAPER TO THE
PRINTER WITH SPECTROPHOTOMETER UNIT MOUNTED" on P. 12. Always use the
same computer for managing paper for adding custom paper and calibration targets.
2. Export the media information file for the new custom paper on the computer for
managing paper by following the procedure in "3. EXPORT THE CUSTOM MEDIA
INFORMATION FILE" on P. 20.
3. Add the new custom paper to the printer driver in the computer and each of the printers
by following the procedure in "4. ADD THE CUSTOM PAPER TO THE OTHER
PRINTERS" on P. 22.
4. Add the new custom paper to the printer driver on the computer for printing by following
the procedure in "5. ADD THE CUSTOM PAPER TO THE COMPUTERS FOR
PRINTING" on P. 24.
5. Load the newly added custom paper into each printer, and execute color calibration.
Q2. HOW DO I ADD A PRINTER TO USE?
A2. Use the following procedure.
1. Connect the new printer to the computer for managing paper and install the printer driver
for the new printer.
2. Check whether any custom paper has been added to the new printer, and delete all of
the existing custom paper if it has.
3. Add the new custom paper to all of the printers by following the procedure in "4. ADD
THE CUSTOM PAPER TO THE OTHER PRINTERS" on P. 22.
4. Connect the new printer to the computer for printing, and install the printer driver for the
new printer.
5. Add the custom paper to the printer driver newly installed on the computer for printing by
following the procedure in "5. ADD THE CUSTOM PAPER TO THE COMPUTERS FOR
PRINTING" on P. 24.
6. Load the paper into the new printer, and execute color calibration.
To Next Page
Loading...
Need help?
General