33
Error messages
Check the message and take the appropriate action.
Before borderless printing, move the blue platen switch. •
Blue platen switch is dirty. •
Borderless printng not possible. •
Borderless printng not possible. Paper stretched or shrank. •
Calibration There is a problem with the multi-sensor. •
Cannot adjust paper feed. •
Cannot adjust printhead. •
Cannot calibrate. •
Cannot cut paper. •
Cannot detect papr •
Cannot execute this command. Use other paper. •
Cannot feed paper. •
Check printed document. •
Close Ink Tank Cover •
End of paper feed. •
ERROR Exxx-xxxx (x represents a letter or number) •
Excessive temperature or humidity. •
Execute printhead cleaning. •
File read error. •
GARO Wxxxx (x represents a number) •
Hard disk error. •
Hardware error. xxxxxxxx-xxxx (x represents a letter or number) •
Ink insuffi cient. •
Ink tank is empty. •
Insuffi cient paper for job •
Mail box full. Now printing without saving data. •
Mail box nearly full. •
Maint. cart. The level is low •
Maintenance cartridge full. •
Maintenance cartridge problem. •
Maximum jobs stored. •
Media take-up unit ready. •
MediaType Mismatch •
Move the blue platen switch No.xx to the right. (xx represents a number) •
Multi-sensor error •
No ink left. •
No ink tank loaded. •
No maintenance cartridge. •
No Maintenance Cartridge capacity. •
No sheets. •
No x printhead (x is L, R, or not displayed) •
Not much ink is left. •
Paper loaded askew. •
Paper mismatch •
Paper position not suitable for borderless printing. •
Paper size not detected. •
Error Messages
Respond to error messages as follows.
To Next Page