Important
•
Here, the Belt Stopper is the one that was removed and stored after initial installation. Neglecting to
attach the Belt Stopper may damage the printer.
•
Do not touch the Linear Scale (a), Carriage
Shaft (b), or Ink Tube Stabilizer (c). Touching
these parts may damage them.
4
Close the Top Cover.
5
Tape down printer covers to secure them, in the re-
verse order of tape removal during installation.
6
Remove and package the Stand by reversing the installation procedure, when it was attached to the printer.
7
Disassemble and repackage the Stand by following the installation procedure in reverse.
8
Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a
shipping box.
Preparing to Transfer the Printer
iPF840 Series
Basic Guide
Printer Relocation Preparing to Transfer the Printer
78
To Next Page
Loading...
Need help?
General