Setting Up the Connection
1-19
Before You Start Using This Machine
1
Connecting to a USB Interface
You can connect the machine to a computer with a USB port via a USB cable. The
machine is USB 2.0 high-speed* compatible. The drivers, USB class driver, and
utility that matches the operating system on your computer must be installed. For
more information on installing the driver through USB connection, see the Printer
Driver Installation Guide. For more information on installing the utility software
included on the disc, see “UFR II LT User Software disc,” on p. 1-23.
* This depends on the specifications of the operating system of your computer.
CAUTION
• Before you connect the USB cable to the machine while the main power switch
is ON, make sure the ground line is connected. If the ground line is not
connected, connecting the USB cable to the machine while the main power
switch is ON may result in electric shock.
• If you connect or disconnect the USB cable while the main power switch is ON,
do not touch the metal parts around the connector, otherwise this may result in
electric shock.
IMPORTANT
•
Do not connect or disconnect the USB cable in the following situations (otherwise poor
operation of your computer or machine may result):
- When installing the driver
- When the computer is booting up
- When printing
•
If you disconnect the USB cable with the computer or machine’s main power switch ON,
always wait at least 10 seconds before reconnecting the cable. Immediately
reconnecting the cable may result in poor operation of your computer or machine.
UFR II LT User Software disc
USB Cable
USB Port
The USB connector is located on
the back side of the machine.
To Next Page
Loading...
Need help?
General
