15
XI CONFIRMATION REPORT
To Request For A Transmission (TX) Report Only For One Particular
Sending
Setting up the Program One-Touch Key
1. Open all three all three panel covers
2. Press Data Registration
3. Press ▼ until display shows “3. FAX SETTINGS”
4. Press OK to display “1. USER SETTINGS”
5. Press OK
6. Press ▼ until display shows “6. PROG 1-TOUCH KEY”
7. Press OK
8. Press ▼ to an available speed-dial number to which you want to
assign
9. Press OK
10. Press ▼ to display “USE”
11. Press OK to display “1. PRINT REPORT”
12. Press OK again
13. Press Stop
To activate the TX Report
1. Press the speed dial number which has been assigned for TX report
2. Press * to confirm
3. Start the usual sending
After the transmission, the machine will print TX REPORT for that sending
only.
To Next Page
Loading...
