Setting a Wait Time for Connecting to a Network
0W20-03K
When a network is designed to enjoy redundant connectivity with multiple switching hubs or bridges, it must have a
mechanism to prevent packets from looping. One effective solution is to dene the role of each switch port. However,
communication may still be disrupted for several tens of seconds immediately after you change the way that network
devices are connected, or if you add a new device. If this type of problem occurs, set a wait time for connecting to the
network.
1
Press .
2
Use / to select <Network Settings>, and press .
● If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press .
Logging on to the Machine(P. 34)
3
Select <Waiting Time for Connection at Startup>, and press .
4
Enter the wait time in seconds, select <Apply>, and press .
● Use / or the numeric keys to enter the time.
LINKS
Conguring Ethernet Settings(P. 177)
Changing the Maximum Transmission Unit(P. 179)
Network
180
To Next Page
Loading...
Need help?
General