70
13. Restart the projector.
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
14. After the startup logo, open the On-Screen Display (OSD)
menu. Go to the SYSTEM SETUP: Advanced > Lamp
Settings menu. Press OK/IMAGE. The Lamp Settings
page is displayed. Press to highlight Reset lamp timer
and press OK/IMAGE. A warning message is displayed
asking if you want to reset the lamp timer. Highlight Reset
and press OK/IMAGE. The lamp time will be reset to '0'.
Do not reset if the lamp is not new or replaced.
10. Put the lamp protection film supplied with the new lamp on
the lamp compartment.
11. As shown in the figure, place the lamp cover on the
projector.
12. Tighten the screws that secure the lamp cover.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screws.
Notice
Reset Lamp Time ?
Reset
Cancel
To Next Page
Loading...
Need help?
General
