7-5
Maintenance
Fuser Roller
If black streaks appear with printing, the
fuser roller in the main unit may be dirty.
Should this occur, clean the fusing roller
in the following procedure. The roller
should also be cleaned each time the
toner cartridge is replaced. Load a sheet
of blank A4 paper into the multi-purpose
tray and start cleaning.
NOTE
Cleaning the roller takes approximately 130
seconds.
1 Press [Additional Functions].
2 Press [ ] or [ ] to select
<ADJUST./CLEANING>, then
press [OK].
3 Load a sheet of blank A4 paper
in the multi-purpose tray.
4 Press [ ] or [ ] to select
<FIX. UNIT CLEANING>, then
press [OK].
Cleaning starts. When finished, the display
returns to the standby mode.
NOTE
– Use standard paper as the cleaning
paper.
– Throw away the cleaning paper after use.
To Next Page
Loading...
Need help?
General
