Precautions for Safe Transport of the Machine
When relocating the machine, make sure of the following.
Important
When sending the machine for repair
Pack the machine in a sturdy box so that it is placed with its bottom facing down, using
sufficient protective material to ensure safe transport.
With the print head and ink tank left installed in the machine, press the ON button to
turn off the power. This allows the machine to automatically cap the print head, thus
preventing it from drying.
After packing, do not tilt the box containing the machine or turn it on its side or upside
down. Doing so may cause the ink to leak during transport and cause damage to the
machine.
When a shipping agent is handling transport of the machine, have its box marked "THIS
SIDE UP" to keep the machine with its bottom facing down. Mark also with "FRAGILE"
or "HANDLE WITH CARE".
1. Turn the machine off.
2. Confirm that the POWER lamp is off and unplug the machine.
Notice for Unplugging the Power Cord
Important
Do not unplug the machine while the POWER lamp is lit or flashing, as it may cause
malfunction or damage to the machine, making the machine unable to print.
3. Retract the paper output support, then close the paper output tray.
4. Retract the output tray extension and the paper support, then close the
front tray.
5. Disconnect the printer cable from the computer and from the machine,
then disconnect the power plug from the machine.
312
To Next Page
General
