2 times: Kana font
5) Press the Stop/Reset button to return to the menu selection of the service mode (Service Model Idle).
<Ink absorber counter setting>
Set the ink absorber counter value to a new EEPROM after the logic board is replaced in servicing.
1) Before replacement of the logic board, check the ink absorber counter value in EEPROM information
print.
2) In the service mode, press the Stop/Reset button 13 times, then press the ON/OFF button to enter the
ink absorber counter setting mode.
3) Press the Stop/Reset button the specified number of time(s) according to the ink absorber whose value
should be set.
Time(s) *1 Ink absorber
0 times Main ink absorber
1 time Platen ink absorber
2 times Both the main and platen ink absorbers
3 times or more Press the ON/OFF button to return to the ink amount setting mode.
4) Press the ON/OFF button to enter the ink absorber counter setting mode.
5) Press the Stop/Reset button the appropriate number of time(s) to select the value which is closest to the
actual ink absorber counter value. (
The ink absorber counter value can be set in 10% increments.)
Time(s) Ink absorber counter value to be set (%)
0 times 0%
1 time 10%
2 times 20%
3 times 30%
4 times 40%
(16/32)
To Next Page
Loading...
