5 times 50%
6 times 60%
7 times 70%
8 times 80%
9 times 90%
10 times or more
Not valid.
Press the ON/OFF button to return to the ink absorber counter
setting mode.
6) Press the ON/OFF button to set the selected value to the EEPROM. Print EEPROM information to
confirm that the value is properly set to the EEPROM.
*1: According to the number of times the Stop/Reset button is pressed, the LED lights as follows:
- Odd number of times: Alarm LED lights
- Even number of times: ON/OFF LED lights
2-2. PTT Parameter Mode
2-2-1) FAX PTT parameter mode
Enter the PTT parameter mode from the user mode, but not from the service mode.
How to enter the PTT parameter mode:
1) In the user mode, press the SCAN button to enter the scan mode.
2-a) Press #, 9, 7, 6, 9, # to enter the PTT parameter mode.
2-b) Press #, 9, 7, 6, 8, # to print the PTT parameter setting value.
How to finalize the data:
Press the OK button to finalize the data and press the Stop/Reset button to save the data.
How to finish the PTT parameter mode:
Press the ON/OFF button to save the specified data in the EEPROM and turn off the machine.
2-2-2) How to enter the PTT parameter mode
1. In the user mode, press the SCAN button to enter the scan mode and press #, 9, 7, 6, 9, #.
2. The following message is displayed on the LCD.
PTT PARAMETER
#1 BIT SWITCH
BIT SWITCH menu
3. Each time the right or left arrow key is pressed, the menu is changed.
PTT PARAMETER
#2 NUMERIC PARAM.
(17/32)
To Next Page
Loading...
