Name: Canon Power Shot SD30
Brand: Canon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Installing the Battery.

1. Slide the memory card slot/battery cover and open it ( ,

2. Push the battery lock in the direction of the arrow (

)

, align

the symbol on the battery and inside of the

memory card

slot/battery cover

and insert the battery until it locks into

place (

)

To remove the battery, push the battery lock in the direction of

the arrow ( ) and hold it while pulling the battery out.

3. Close the memory card slot/battery cover.

Charging the Battery.

Charge the battery before use under the following circumstances.

• When using the battery for the first time.

• When the "Change the battery pack" message displays.

Preparations

The bottom of the camera station has non-slip rubber feet.

• The rubber feet are covered with a thin orange plastic film. Carefully

peel the film off before use.

• If dirt adheres to the rubber feet, lightly wipe them with a slightly

dampened cloth.

Battery Lock

symbol

Preparations

170CUGBook(Basic-Advanced).book Page 1 Tuesday, June 21, 2005 10:02 PM

Questions and Answers:

Need help?

Do you have a question about the Canon Power Shot SD30 and is the answer not in the manual?

Canon Power Shot SD30 Specifications

General