13
Selecting and Printing Images
You can select an image and specify the number of copies for printing. In this section, an SD memory card
will be used as an example, but you can print from other memory cards using the same steps.
Turn on SELPHY.
O Press and hold the q button until the screen shown at
left displays.
O To turn the power off, press and hold the q button and
release when the screen display changes.
Approx. 45°
Raise the screen (LCD monitor).
O Do not raise the LCD monitor more than 45° as this may
result in damage or malfunction.
Label side
Insert a single memory card into the slot.
O Insert the card faced as shown in the illustration until it
clicks.
O To remove the card, push it in until it clicks and release
your nger slowly.
O If you are using a CF/microdrive card, insert it fully into
the appropriate slot.
X The screen in Step 4 below (image display screen)
(p. 7) will display.
Number of copies for the
displayed image
Number of copies
Select an image.
O Press the lr buttons to select an image to print.
O Every 5th image will be displayed if you press and hold
the lr buttons.
Select the number of copies.
O Press the ud buttons to select the number of copies.
O If you press and hold one of the ud buttons, the
number increases or decreases by 5 copies.
O To print another image at the same time, repeat Steps 4
and 5.
1
2
3
4
5
To Next Page
Loading...
Need help?
General
