58
Playing Back a Tape with Added
Sound
You can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjust
the balance of both sounds.
1. Open the FUNC. menu, select ( ) the icon and press ( ).
2. Select ( ) the [AUDIO SETUP] menu and press ( ). Then, select
( ) the [12bit AUDIO] option and press ( ).
3. Select a setting option and press ( ) to save the changes.
• STEREO1: Plays back the original sound.
• STEREO2: Plays back the added sound.
• MIX/FIXED: Plays back Stereo 1 and Stereo 2 in the same level.
• MIX/VAR.: Plays back Stereo 1 and Stereo 2. The mix balance can be adjusted.
• If you select an audio setting other than [MIX/VAR.], close the menu.
To adjust the mix level when you select [MIX/VAR.]:
4. From the [AUDIO SETUP] menu select ( ) the [MIX BALANCE]
option and press ( ).
5. Adjust ( ) the mix level between ST-1 and ST-2 and press ( ) to
save the changes, then close the menu.
The camcorder resets to [STEREO1] when you turn the camcorder off.
However, the mix balance is memorized by the camcorder.
Audio dubbing cannot be performed with your camcorder.
MENU
(33)
AUDIO SETUP 12bit AUDIO STEREO1
To Next Page
Loading...
Need help?
General
