List
of
Messages
Message
Explanation
[IJ
SET THE TIME ZONE,
You
have not set the time zone, date and time. This message
21
DATE AND TIME
appears each time you turn the power on until you set the time
zone, date and time.
CHANGE THE BATTERY
Battery pack is exhausted. Replace or charge the battery pack.
14
PACK
THE TAPE
IS
SET FOR
Cassette is protected. Replace the cassette
or
change the
116
ERASURE PREVENTION
position
of
the protect switch.
REMOVE THE
Camcorder stopped operating to protect the tape. Unload and
17
CASSETTE
reload the cassette.
CHECK THE INPUT
DV cable is not connected,
or
the connected digital device is
73
turned off.
CONDENSATION HAS
Condensation has been detected
in
the camcorder.
113
BEEN DETECTED
CONDENSATION HAS
Condensation has been detected
in
the camcorder. Unload the
113
BEEN DETECTED
cassette.
REMOVE THE
CASSETTE
TAPE END
Tape reached the end. Rewind the tape or replace the cassette.
-
CHECK THE CASSETTE
You
attempted to perform audio dubbing on a tape recorded
in
a
76
[REC MODE]
mode other than the SP mode.
CHECK THE CASSETTE
You
attempted to perform audio dubbing on a tape recorded
in
16-
76
[AUDIO MODE]
bit
or
12-bit 4-channel sound.
CHECK THE CASSETTE
You
attempted to perform audio dubbing on a tape with a blank
76
[BLANK]
section.
CHECK THE CASSETTE
You
attempted to perform audio dubbing on a tape recorded
in
HD
-
[INCORRECT TAPE
standard.
SPECIFICATION]
INCORRECT TAPE
You
attempted to play back a tape recorded
in
HD standard.
-
SPECIFICATION
PLAYBACK IS
RESTRICTED
INPUT SIGNAL NOT
You
attempted to input video signal
in
HD standard through the
73
SUPPORTED
DVterminal.
HEADS DIRTY, USE
Video heads are dirty. Clean the video heads. 113
CLEANING CASSETTE
COPYRIGHT
PROTECTED
You
attempted to play back a copyright protected tape.
73
PLAYBACK
IS
RESTRICTED
COPYRIGHT PROTECTED
You attempted to dub a copyright protected tape. May also appear
73
DUBBING RESTRICTED
when an anomalous signal is received during analo.g line-in
recording, or during analog-digital conversion
of
a copyright
protected tape.
Message
Explanation
[IJ
NO CARD
Memory card not is inserted into the camcorder.
80
THE CARD
IS
SET FOR
SD Memory Card is set for erasure prevention. Replace the card
80
ERASURE PREVENTION
or
change the position
of
the protect switch.
NO IMAGES
No images are recorded on the memory card.
-
-
109
To Next Page
Loading...
Need help?
General
