20 21
ASSEMBLY FROM THE BIKEGUARD ASSEMBLY FROM THE BIKEGUARD
Charge the batteries with the supplied charger.
The electrical contacts at the front and rear de‑
railleur are protected with a red cover. Remove
these covers by opening the locking mechanism
upwards.
Fix the battery by closing the locking mechanism.
The locking mechanism must engage audibly.
You nd more information in your bicycle manual
road bike and at www.sram.com
Take the battery and insert it with its contacts
showing upwards.
Be sure to charge the battery only with
the battery charger supplied. Do not use
the charger from another manufacturer, even if
the plugs of the battery charger t into your
rechargeable battery.
Check the proper functioning of the gears. Shi
through all the gears. Make sure that the rear de‑
railleur does not collide with the spokes when the
chain runs on the largest sprocket.
For more information on how to adjust the gears
read the chapter “The gears” in your bicycle man‑
ual road bike.
Aer the wheel mounting do a brake test at
standstill. Actuating the brake lever should gener‑
ate a clear‑cut braking response before the lever
touches the handlebars.
Adjusting the gears of a bike with disc
wheels requires a certain amount of ex‑
perience and should, therefore, be le to a
skilled mechanic. If in doubt, ask an expert to
adjust your Canyon Speedmax. However, if you
want to do this adjustment on your own, re‑
strict yourself to work for which you have the
necessary expert knowledge and the suitable
tools.
For more information read the chapter
“Shimano Di2” in your bicycle manual
road bike or at si.shimano.com or www.sram.com
Never ride your Canyon if the MAX
marking of the seat post is visible.
Adjust the position of the saddle, the grip position
and check the rm seat of the handlebars, the
grips and the seat post, as described in the chap‑
ter “Adjusting the Canyon Speedmax to the rider”.
CHECKING AND ADJUSTING
To Next Page
Loading...
