Capacity of Texas, Inc.
92
P0123 Pedal Position Sensor
High Voltage
No Use default throttle values.
Freezes shift adapts.
P0218 Transmission Fluid
Over Temperature
No Use hot mode shift
schedule. Holds fourth
range. TCC is inhibited.
P0602 TCM Not Programmed Yes Lock in Neutral
P0610 TCM Vehicle Options Yes Use TID A calibration
P0613 TCM Processor No All solenoids off
P0614 Torque Control Data
Mismatch—ECM/
Yes Allows operation only in
reverse and second range.
P0634 TCM Internal Yes SOL OFF (hydraulic
P063E Auto Configuration Yes Use default throttle values
P063F Auto Configuration
Engine Coolant Temp
No None
P0658 Actuator Supply Yes DNS, SOL OFF (hydraulic
P0659 Actuator Supply Yes DNS, SOL OFF (hydraulic
P0702 Transmission Control Yes Uses TID A calibration
P0703 Brake Switch Circuit
Malfunction
No No Neutral to Drive shifts
for refuse packer. TCM
inhibits retarder operation
if a TPS code is also
active.
P0708 Transmission Range Yes Ignore defective strip
P070C Transmission Fluid No None
P070D Transmission Fluid No None
P0711 Transmission Fluid
Temperature Sensor
Yes Use default sump temp
P0712 Transmission Fluid
Temperature Sensor
Yes Use default sump temp
P0713 Transmission Fluid
Temperature Sensor
Yes Use default sump temp
P0716 Turbine Speed Sensor Yes DNS, Lock in current
P0717 Turbine Speed Sensor Yes DNS, Lock in current
Table 4-4 Transmission Diagnostic Codes (Cont.)
Code Description
Check
Trans
Light
Description
To Next Page
Loading...
