aux-in connection
u
Insert one end of the 3.5mm audio cable (not included) into the LINE OUT jack on your external audio unit (e.g. iPad,
iPod shufe, mobile phone, MP3 player, digital media player, etc.) and the other end into the Aux In Jack on rear of
this unit.
v
To listen to the external audio source, turn this unit on by pressing the STANDBY button, then power on the external
audio source. Next press the MODE button to select AUX mode.
w
Press play on the external audio source and the sound will playback through the speakers of the home stereo.
note: It is suggested that you unplug the audio cable when you are not listening to the external audio unit.
CD memory programming (up to 20 tracks)
Programming is the ability to preselect the order in which a series of tracks will be played.
u
While in the STOP mode, press the PROGRAM / CLOCK SET button. “MEM”, the track number and “Pr01”
(the program number) will appear in the display.
v
Select a track to be programmed using the SKIP UP + button or the SKIP DOWN – button.
w
Press the PROGRAM / CLOCK SET button to save the track. Repeat Steps 2 and 3 to program additional tracks
up to a maximum of 20 tracks.
x
Press the PLAY / PAUSE
button to begin program playback.
notes: To CLEAR THE MEMORY while in the STOP mode, press the STOP
button again.
To Next Page
Loading...