Caple C981G - Page 23

23Instruction manual C981G & C1081GPlease keep this instruction manual for future reference
Fault types and codes are shown in the following table:
FAULT TYPE DISPLAYED FAULT CODE SOLUTION
Single burner locked out b
Perform reset procedure as described
in previous sections.
Spurious flame / flame detection
circuit fault on single burner
F
Disconnect electrical power supply
and then reconnect after a few
seconds.
If the problem persists,
contact Caple service.
Main valve control circuit fault FLt00
Reference voltage circuit fault FLt01
Watchdog circuit fault FLt02
Microcontroller ports fault FLt03
Eeprom fault FLt04
Valve drive circuit fault FLt05
Max 5 resets in 15 minutes exceeded FLt06
Perform reset procedure as described
in previous sections.
Supply circuit fault FLt08
Disconnect electrical power supply
and then reconnect after a few
seconds.
If the problem persists,
contact Caple service.
Resonator fault / Generic fault FLt09
Perform reset procedure as described
in previous sections.
All burners locked out FLt0A
Perform reset procedure as described
in previous sections.
Control logic communication errors FLt0C
Disconnect electrical power supply
and then reconnect after a few
seconds.
If the problem persists,
contact Caple service.
Touch panel control error FLt0E