30
ELECTRICAL CONNECTION
• The electrical connection of this appliance to the household electrical supply should be
undertaken by a competent electrician in accordance with the local regulations.
• The mains cable must be positioned so that it does not come into contact with the hot
surfaces of the hob or the cabinet construction.
• The hob must be installed in a way that ensures the cable is not under tension.
• The Connectivity/Rating plate is mounted on the underside of the hob adjacent to the
Mains terminal block.
• The connection to the household electrical supply must be made using an earthed terminal
or via an omnipolar circuit breaking device with a contact opening of at least 3mm.
• In accordance with installation regulations, the appliance must have an accessible means
of isolation from the household electrical supply, for example: Suitable isolation switches,
circuit breakers, fuses etc.
Caution!
This appliance is only to be connected to a 220/240V~ 50/60Hz supply
Always connect the Earth Wire.
Respect the connection diagram.
The connection box is located underneath at the back of the hob casing. To open the cover, use
a medium screwdriver.
Mains Connection Cable diameter
Cable protection Ampage
220/240V~ 50/60Hz
1 Phase + N
2 Phase
5 x 2,5 mm²
H 05 VV - F
H 05 RR - F
40 A *
400V~ 50/60Hz 2 Phase + N 5 x 2,5 mm²
H 05 VV - F
H 05 RR - F
25 A *
400V~ 50/60Hz 3 Phase + N 5 x 2,5 mm²
H 05 VV - F
H 05 RR - F
16 A *
* calculated with the simultaneous factor following the standard EN 60 335-2-6
NORMAL UK CONNECTION
To Next Page
Loading...
