Instruction manual Di64242 Please keep this instruction manual for future reference
DISHWASHER INSTALLATION STEPS
1. Affix the condensation strip under the work surface of cabinet. Please ensure the condensation
strip is flush with edge of work surface. (Step 1)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position.
6. Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by turning
the Philips screw in the middle of the base of dishwasher. To adjust the front feet, use a flat
screw driver and turn the front feet until the dishwasher is level. (Step 4)
7. Install the furniture door to the outer door of the dishwasher. (Step 2)
8. Adjust the tension of the door springs by using an screwdriver and turning in a clockwise
motion to tighten the left and right door springs. Failure to do this could cause damage to your
dishwasher. (Step 3)
9. The dishwasher must be secured in place. There are two ways to do this:
› Normal work surface: Put the installation hook into the slot of the side plane and secure it to
the work surface with the wood screws.
› Marble or granite work top: fix to the side panel with the screws provided.
A
B
To Next Page
