Instruction manual WDU060, WDU080 & WDU125 21Please keep this instruction manual for future reference
INSTALLATION AND OPERATING INSTRUCTIONS:
1. Drill a hole of 33mm to 35mm into the sink or worktop where the Actuator Button (1) is to
be placed.
2. Insert, from the top, the Actuator Outlet (3) through the drilled hole and secure by tightening
the Actuator Nut (2).
3. Firmly connect Air Tube (4): one end to the Actuator Outlet (3) and one end to Sensor Inlet (5).
4. Plug Disposer Power Cord (6) into main electrical service.
5. The Air Switch is supplied in the off position. To turn on the disposer, press Actuator Button (1).
To turn off, press Actuator Button again.
6. For use with the wall switch - first plug the disposer power cord into the outlet controlled by the
wall switch. Then install the tube and actuator button on the disposer and press the button to
place the air switch in the “on” position.
NOTE:
The disposer will turn on at this time. Then, remove the tube and button. The disposer can now be
controlled with the wall switch.
To Next Page
Loading...
