12 Instruction manual WF1552 & WF1553 Please keep this instruction manual for future reference
LOWER ZONE
› The temperature setting has the following range:
Lower compartment: 10 - 18ºC
› To view the actual temperature inside the wine cabinet, press the or key and hold
for approximately 5 seconds. The actual temperature of the upper or middle zone will be
displayed on the control board. After 5 seconds the temperature will return to the
set temperature.
› Flashing LED = Cabinet Temperature
› Steady LED = Set Temperature
NOTE
If the unit is unplugged, power lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the wine cabinet will
not start.
When you use the wine cabinet for the first time or you restart the cabinet after having been
shut off for a long time, there could be a few degrees variance between the temperature you
select and the one indicated on the LED readout. This is normal and it is due to the length of
the activation time. Once the wine cabinet has been running for a few hours everything will be
back to normal.
TEMPERATURE RECOLLECTION FUNCTION
In the event of a power interruption, the wine cabinet remembers the previous temperature
settings. When the power is recovered, the cabinet temperature will go back the same setting
temperature prior to powering off.
TEMPERATURE ALARM
If internal cabinet temperature is higher than 23°C, “HI” is shown in the display panel, and the
alarm sounds after one hour continuously to warn that the inner temperature is too high.
If internal temperature is lower than 0°C, “LO” is shown in the display panel, the alarm sounds
and the malfunction indicator lights up at the same time.
To Next Page
Loading...
