EasyManua.ls Logo

Caple WF334 - Troubleshooting

Caple WF334
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 19Instruction manual WF334 Instruction manual WF334Please keep this instruction manual for future reference Please keep this instruction manual for future reference
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE
The wine cabinet does not operate Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
The wine cabinet is not cold enough Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The compressor turns on and
off frequently
The room temperature is hotter than normal.
A large amount of contents has been added to the wine cabinet.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The light does not work Not plugged in.
The circuit breaker tripped or a blown fuse.
The bulb has burned out.
The light button is “OFF”.
Vibrations Check that the appliance is even
The Wine cabinet seems to make
too much noise.
The rattling noise may come from the flow of the refrigerant, which is
normal. As each cycle ends, you may hear gurgling sounds caused by the
flow of refrigerant in your wine cabinet.
Contraction and expansion of the inside walls may cause popping and
crackling noises.
The wine cabinet is not level.
The door will not close properly The wine cabinet is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.
If the above table has not solved the problem please contact Caple Service by phone on
0117 938 7420 or by email service@caple.co.uk
You can solve many common wine cabinet problems easily, saving you the cost of a possible
service call. Try the suggestions below to see if you can solve the problem before calling
Caple Service.
DEFROSTING/CONDENSATION
Your wine cabinet is designed with an “Auto-cycle” defrost system. When the RUN cycle is
OFF, the refrigerated surface of the wine cabinet (interior rear wall) defrosts automatically. The
defrosted water is channelled into a drain pan which is located at the back of the cabinet next
to the compressor from where it evaporates.
HUMIDITY SYSTEM
The wine cabinet is equipped with a system for maintaining the correct level of humidity. If
humidity is too low, insert the small plastic reservoir on to the top shelf. Fill this reservoir 3/4
full with water. Check the water level occasionally and refill as necessary.

Related product manuals