Why my Caple WMI4001 Washer does not work?
If your Caple Washer isn't starting, ensure it's properly plugged into a working socket and that the power is on. Test the socket with another appliance. Also, make sure the door is correctly closed, the right program is selected, the start button is pressed, and that the washer isn't in pause or time delay mode.
What to do if my Caple WMI4001 displays E7 error?
If you see error code E7 on your Caple Washer, make sure the door is correctly closed and that no clothes are preventing it from fully closing. If the door is locked, switch off and unplug the washing machine, wait 2-3 minutes, and then try reopening the door.
Why Caple WMI4001 does not spin?
If your Caple Washer isn't spinning, it could be due to several reasons. The machine might be trying to balance the load, which increases the spin time, or reducing the spin speed to minimize vibrations. In some cases, the spin cycle may even stop to protect the machine and the load. If this happens, remove the load, untangle it, reload it, and restart the spin program. Also, water might not have completely drained, so wait a few minutes. Check if the 'no spin' function is selected or if excessive detergent is impeding the spin cycle. Ensure you're using the correct amount of detergent.
How to fix E2 error on Caple WMI4001 Washer?
If your Caple Washer displays error code E2, ensure the water supply tap is open and the supply hose isn’t bent or trapped. Also, confirm the drain pipe is at the correct height as shown in the installation section. Close the tap, unscrew the filler hose, and check the anti-sand filter to make sure it’s clean.
What to do if my Caple WMI4001 Washer displays E3 error?
If your Caple Washer displays error code E3, check if the filter is clogged and ensure the drain hose isn’t bent or trapped. Also, verify that the home drainage system isn't blocked by trying to drain water in the sink.
Why is my Caple WMI4001 Washer vibrating so much?
If your Caple Washer is making strong vibrations or noises during the spin cycle, it might not be fully leveled. Adjust the feet as shown in the manual. Also, ensure that the transport screws, rubber bungs, and spacer tubes have been removed and that there are no foreign objects inside the drum.
What to do if my Caple WMI4001 Washer displays E4 error?
If you see error code E4 on your Caple Washer, make sure you're using the correct amount of detergent and that it's designed for use in a washing machine.
Why is my Caple WMI4001 Washer leaking water?
If water is leaking on the floor near your Caple Washer, make sure the front filter is correctly closed. The leak might be from the seal between the tap, supply hose, and fill valve; if so, replace it and tighten the hose connections correctly.
To Next Page
General
