Operation Instructions
12
CAUTION:
a.Do not store a spare LP-gas cylinder under or near this appliance.
b.Never ll the cylinder beyond 80 percent full.
c.If the information in (a) or (b) is not followed exactly, a re causing death or serious injury may occur.
ENJOY YOUR CAPTIVA DESIGNS
Before connection, be sure that there is no debris caught in the outlet of the gas cylinder, outlet of the
regulator valve or in the outlet of the burner and burner ports. Connect regulator valve and hand-tighten
rmly. Keep the propane cylinder valve closed and disconnect the propane cylinder from the regulator
valve when the grill is not in use.
DO NOT obstruct the follow of combustion air and ventilation air to the grill. The propane cylinder must be
arranged for vapor withdrawal and equipped with a listed overlling prevention device. Please use the
proper cylinder orientation to provide vapor withdrawal. NOTE: The cylinder must be fully upright for the
cylinder to have vapor withdrawal only.
1. The knob on the LP tank must be closed. Make sure that the knob is
turned clockwise to a full stop. The cylinder supply system must
be arranged for vapor withdrawal.
2. Check that the control knob on the control unit is turned off.
3. Remove the protective cap from the LP tank valve and coupling nut.
4. Hold the regulator in one hand and insert the nipple into the valve
outlet. Be sure the nipple is centered in the valve outlet. The coupling
nut connects to the large outside threads on the valve outlet. Use care
do not cross thread the connection.
5. Hand-tighten the coupling nut clockwise until it comes to a full
stop. Firmly tighten by hand only. Do not use tools.
To Disconnect: Fully close the tank valve by turning clockwise.
Turn the coupling nut counterclockwise until the regulator assembly detaches.
To Next Page
Loading...
