To Next PageTo Next Page
Need help?Do you have a question about the Cardin 1524 and is the answer not in the manual?
Crucial safety advice to read instructions before installation.
List of numbered components used in the installation diagram.
Key points for proper installation and usage of the gate automation system.
Mandatory safety measures for installers and users to prevent accidents.
Details on power, motor, and system components.
List of compatible accessories for the gate automation system.
Detailed steps for securely mounting the geared motor unit.
Instructions for attaching the toothed rack to the gate.
Explanation of display messages and indicator LEDs status.
Interpreting display symbols for operational status and errors.
Configuration of system functions via dip-switches.
Procedure for calibrating the motor's current sensor.
Accessing system status, manoeuvre count, and test mode.
Adjusting the maximum opening distance for the gate.
Setting functions for remote control channels.
Procedures for memorizing and cancelling transmitter codes.
Guidelines for connecting the external antenna.
Operation with automatic reclosing enabled.
Operation requiring separate open and close commands.
Direct control of gate movement using buttons.
Using dedicated inputs for manual gate leaf control.
Display indications for battery charge level.
Behavior and limitations when running on battery power.
Crucial safety advice to read instructions before installation.
List of numbered components used in the installation diagram.
Key points for proper installation and usage of the gate automation system.
Mandatory safety measures for installers and users to prevent accidents.
Details on power, motor, and system components.
List of compatible accessories for the gate automation system.
Detailed steps for securely mounting the geared motor unit.
Instructions for attaching the toothed rack to the gate.
Explanation of display messages and indicator LEDs status.
Interpreting display symbols for operational status and errors.
Configuration of system functions via dip-switches.
Procedure for calibrating the motor's current sensor.
Accessing system status, manoeuvre count, and test mode.
Adjusting the maximum opening distance for the gate.
Setting functions for remote control channels.
Procedures for memorizing and cancelling transmitter codes.
Guidelines for connecting the external antenna.
Operation with automatic reclosing enabled.
Operation requiring separate open and close commands.
Direct control of gate movement using buttons.
Using dedicated inputs for manual gate leaf control.
Display indications for battery charge level.
Behavior and limitations when running on battery power.
Power| power supply | 230 Vac |
|---|---|
| frequency | 50 Hz |
| current input | 0.9 A |
| power input | 200 W |
Performance| duty cycle | 70 % |
|---|---|
| drag speed | 9.3 m/min |
| reduction ratio | 1/52 |
| maximum torque | 74 Nm |
| shaft revolutions | 50 revs/min |
Operating Environment| operating temperature range | -20°…+55 °C |
|---|---|
| protection grade | IP 44 |
Motor| motor power supply | 37 Vdc |
|---|---|
| maximum power input | 130 W |
| nominal current input | 3.5 A |
Incorporated Receiver Card| reception frequency | 433.92 MHz |
|---|---|
| number of channels | 4 |
| number of functions | 2 |
| number of memorisable codes | 300 |
