- 9 -
7. MAINTENANCE
1.
When running belt is off the center, stop the
treadmill immediately, use Allen Wrench
6mm to adjust the hex head screw. For
example, the running belt is offset to the left it
should adjust 1/4 circle clockwise; if the
running belt is offset to the right, adjust 1/4
circle counterclockwise. After adjustment,
start the treadmill again, if the running belt
still off the center, repeat the adjusting
procedure till the running belt is in the center
position.
(Ps.1. This action is very important, if a
deviated belt is found, be sure to follow above
procedure.)
(Ps.2. Belt may move away from center status
due to user’s weight and running condition.
The belt needs not to be adjusted as long as it
doesn’t rub against the parts aside.)
2. It is strongly suggested to follow the below
table to apply lubrication on running board.
Please use Allen Wrench 6mm to loosen bolts
in rear adjusting boxes. Pull up the running
belt and apply lubrication evenly on the center
of the running board, then adjust the belt to the
center of deck, follow by tighten the screw to
the original set up.
(Ps. When the belt is sliding, please follow the
above method to apply lubricant on the running
board.
)
Speed Suggested Time
1~6 mile 1 year
6~10 mile 6 months
To Next Page
Loading...
