- 6 -
5. ASSEMBLY STEPS
Two persons are required to finish the
assembly steps.
(Caution!! Please follow exactly the assemly
steps below to aviod injury . )
1. Tie up the lower Control Wires of the
Frame (B) with the Guide Thread of the
right Upright (D), pull it into the Upright,
secure it with wire clip and then insert it
into the Upright(shown as the right
drawing)
2. Place the Uprights (C, D) onto the
Frame and then secure with Allen Bolt
(a), Washer (b) in the direction shown in
the drawing.
Ps.1. To avoid unexpected accident,
always assemble the treadmill with
one or two assistants, please do not
assemble by oneself.
Ps.2. When assemble the Upright, one
person should hold the Upright to
prevent the Upright from falling.
a
b
a
b
a
b
a
b
C
D
B
3. After the Uprights are tightened, pull out
the Control Wire which has been threaded
into the Upright to the place shown in the
right picture. Then cap the left and right
Cover (F, G) onto the Frame shown in the
right picture. Tighten them with Screw
(d).
F
G
d
d
d
To Next Page
Loading...
