6. TROUBLESHOOTING
6.1 SOFT RESET
If your FREECOM4x stops responding, reset it in one of these ways:
● Turning it off and then on again (see Switching Your Unit On/Off).
● Using the supplied USB cable, connect your unit to the computer or wall charger for 30 seconds.
6.2 RESET TO FACTORY SETTINGS
This option deletes all paired units, devices and all configuration settings.
To perform a factory reset through the unit:
1. Check that your FREECOM4x is in Standby mode.
2. Simultaneously press + + for 5 seconds.
The LED flashes purple 5 times slowly, confirming that pairing has been reset.
6.3 FAQ
Additional answers to common problems can be found at www.cardosystems.com/support/freecom-4x/
21
To Next Page
Loading...
