Cardo Systems scalarider Q3 - 5.2 Pairing Intercom Channels; Scala Rider Intercom Pairing Procedure; 5.3 Intercom Call Management; Making, Receiving Calls & Using VOX

5.2 PAIRING INTERCOM CHANNELS
NOTE: Pairing a Channel will replace any existing paired device on
that Channel with the new device.
If you have purchased the Q3 MultiSet, the retail package contains
two pre-paired units congured to communicate via their “IC”
buttons on Channel A.
If for any reason you have to pair them again, OR if you wish to pair
another unit, proceed as follows:
1. Check both scala riders are in Standby (single BLUE ash every
3 seconds).
2. On the rst unit, press and hold the “IC” button for 5 seconds.
Once the LED begins ashing, select the intercom channel you
would like to pair by tapping the “IC” button (Channel “A” pairs
automatically).
INTERCOM
CHANNEL
PAIRING PAIRING MODE LED
INDICATORS
“A” (Default) No action required Rapid RED ashing
“B” Tap “IC” x2 Rapid BLUE ashing
“C” Tap “IC” x3 Rapid PURPLE ashing
3. Immediately repeat Step 2 on the second unit. Both units will
now be in Intercom Pairing mode.
4. After a few seconds, both units will show a solid light for
2 seconds, indicating that they are paired and ready to use.
NOTE: If Pairing is not completed within two minutes, the units will
return to Standby mode.
5.3 MAKING INTERCOM CALLS
Call Channel A Tap “IC” once
Call Channel B Tap “IC” twice
Call Channel C Tap “IC” three times
End Intercom call Tap “IC”
Voice Connect (VOX)
Use VOX to make Intercom Calls to your Priority Intercom Channel
Set Priority Channel
(Default: Channel A)
Press “V+” for 5 seconds during intercom
call with the selected channel
Call Priority Channel Speak any word loudly into the microphone
NOTE: VOX Intercom call will end automatically after 30 seconds
of silence.
IMPORTANT: VOX and AGC performance will vary based on
environmental conditions including driving speed, helmet type and
ambient noise.
For improved performance, minimize the wind impact on the
microphone by using the large microphone sponge and closing the
visor.
5.4 RECEIVING INTERCOM CALLS
• If another paired scala rider tries calling you via Intercom, the call
will begin almost instantly
• To receive a CTL intercom call see table in section 5.5
8 | scala rider
®
Q3 / Q3 MultiSet™ 8 | scala rider
®
Q3 / Q3 MultiSet™