T
his Quick Guide is not a substitute to the user manual and addresses only
a limited scope of features and functions of your cardo SHO-1. Use it to
look up basic functions and commands while you are on the road without the
user manual.
This Quick Guide can be printed and folded for easy reference while on the
road, or it may be viewed directly on your smartphone or tablet.
scala rider G9 Unit
1
|
GENERAL FUNCTIONS
Power ON / OFF
Press for 2 seconds
• ON: 3 BLUE ashes + ascending tone
• OFF: 3 RED ashes + descending tone
Volume
Tap or to adjust and set volume of current audio source
Mute / Unmute
Tap and simultaneously
Battery level
indicator
In Standby, press and for 5 se conds
• Blue LED = Full charge
• Purple LED = Half charge
• Red LED = Almost empty
Hear Your Buddy
Name
In Standby, tap and simultaneously
Paired Device
Indication
In Standby, press and for 2 seconds
If “One+8” Buddies are within range, purple LEDs ash for
2 seconds
Play Paired Buddy List
In Standby, press for 2 seconds
Group Signal
Tap twice
Enable / Disable VOX
(For Intercom calls only)
In Standby, press and for 2 seconds
• Enabled: Blue ash for 2 seconds
• Disabled: Red ash for 2 seconds
Enable / Disable
Spoken Status
Announcements
Press and for 2 seconds
2
|
VOICE COMMANDS
1. In Standby, tap or speak any word loudly to activate VOX
2. Speak a Voice Command from the table below:
Current Mode Desired Action Say this:
Standby / FM / A2DP
/ AUX
“One+8” Intercom Call <<Buddy Name>>
Intercom call with A or B “Call Intercom”
Standby
Start A2DP “Music ON”
Turn on FM “Radio ON”
FM Radio
Turn o FM “Radio OFF”
Next Station Preset “Next Station”
Previous Station Preset “Previous Station”
A2DP Music
Next track “Next track”
Previous track “Previous track”
Stop / Pause A2DP “Music OFF”
3
|
SETTINGS MENU
Enter Settings Menu
In Standby, press for 2 seconds and follow
the spoken instructions
Exit Settings Menu
Press for 2 seconds
4
|
MAIN UNIT LED INDICATION
None cardo SHO-1 is OFF
1 BLUE ash every 3 seconds Standby mode – No active audio
2 BLUE ashes every 3 seconds
Active mode – Call in progress / music or other
audio source is ON
1 RED ash every 3 seconds Standby mode – Battery is low
2 RED ashes every 3 seconds Active mode – Battery is low
Solid PURPLE USB connected
Solid RED (battery LED) Charging
5
|
VOICE CONNECT VOX
VOX Sensitivity
(Default: Medium)
Adjust via the Settings Menu, the App or the Cardo Community.
High: Use this setting if it is dicult to activate VOX
Low: Use this setting if it is too easy to activate VOX
VOX Operation
Mode
VOX can be set to activate the Voice Command (default) or to
start an Intercom Call via the Cardo Community or the App
6
|
PAIRING BLUETOOTH DEVICES:
MOBILE PHONE/GPS/A2DP MUSIC PLAYER
Bluetooth Channel 1
pairing mode
In Standby, press for 5 seconds
Bluetooth Channel 2
pairing mode
In Standby, press for 5 seconds
To pair a GPS, when LEDs begin rapidly alternating, tap .
™
Volume Down
• Intercom
• On / O
Music and Mobile
Voice Command
Volume Up
To Next Page
Need help?
General
