CareCo scootcase - PG S-Drive Code Error Messages

21
* PG S-Drive Code Error Messages
Flash
Description
1 Bar
The battery needs cha
rging or there is a bad connection to the battery.
Check the connections to the battery. If the connections are good, try
charging the battery.
2 Bar
There is a bad connection to the motor. Check all connections
between the motor & the controller.
3 Bar
The motor has a short circuit to a battery connection. Contact your
service agent.
4 Bar
The freewheel switch is activated or the manual brake disengagement
mechanism is operated. Check the position of the switch or lever.
5 Bar
Not used.
6 Bar
The S-drive is being inhibited from driving. Inhibit 2 is active. This may
be because the battery charger is connected or the seat is not in the
driving position.
7 Bar
A throttle fault is indicated. Make sure that the throttle is in the rest
position before switching on the scooter.
8 Bar
A controller fault is indicated. Make sure that all connections are
secure.
9 Bar
The parking brakes have a bad connection. Check the parking brake
and motor connections. Make sure the controller connections are
secure.
10 Bar
An excessive voltage has been applied to the controller. This is usually
caused by a poor battery connection. Check the battery connections.