EasyManua.ls Logo

Carel heaterSteam UR Series User Manual

Carel heaterSteam UR Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
High Efficiency Solutions
heaterSteam - UR
NO POWER
& SIGNAL
CABLES
TOGETHER
READ CAREFULLY IN THE TEXT!
Electric resistance humidifi er
User manual

Table of Contents

Questions and Answers:

Carel heaterSteam UR Series Specifications

General IconGeneral
ModelheaterSteam UR Series
CategoryHumidifier
Frequency50/60 Hz
Protection RatingIP21
TypeSteam humidifier
CommunicationModbus, BACnet
Water TypeDemineralized water
Water Conductivity125 to 1250 μS/cm
Operating Temperature5 to 40 °C
Operating Humidity10 to 90% RH
Water Connection1/2 inch
Housing MaterialMetal

Summary

Warnings and Safety Precautions

Introduction and Installation Guide

Humidifier Positioning Guidelines

Guidance on optimal placement and clearance requirements for the humidifier.

Wall Mounting Procedure

Step-by-step instructions for mounting the humidifier securely on a wall.

Hydraulic Connections Guide

Supply Water Requirements and Connection

Details on water quality requirements and connection for the supply water.

Electrical Connections and Wiring

Power Supply Cable Connection

Steps for connecting the main power supply cable to the unit.

Control Board Overview and Connections

Location and overview of the main control board and its connections.

Steam Production Command Signals

How to connect signals for controlling steam production (ON/OFF, modulating).

Humidity Probe Control Setup

Instructions for connecting and configuring humidity probes for control.

Supervisor Network and Operation Preparation

Pre-Operation Checks and Preparations

Essential checks to perform before starting the humidifier operation.

Humidifier Commissioning Procedures

Autotest Procedure Explanation

Details on the automatic self-test performed on startup.

Parameter Programming Guide

General information on accessing and modifying operating parameters.

Setting the Set Point (St)

How to set the desired humidity or temperature set point.

Adjusting and Reading Parameters

Procedure for adjusting operational parameters and reading values.

Modifying Configuration Parameters

Steps to modify configuration parameters, including password access.

Configuration and Control Parameters

Parameter Access and Setting Methods

How to access and set various operational and configuration parameters.

Basic Operation Parameter Settings

Parameters controlling basic humidifier functions like operation mode and units.

Serial Communication Parameter Configuration

Settings for serial communication, including address and baud rate.

Control Parameter Settings

Parameters for controlling humidifier behavior, such as humidity thresholds and setpoints.

Alarm Management and Troubleshooting

Comprehensive Alarms Table

Lists alarm codes, causes, conditions, and possible solutions for troubleshooting.

Autotest Retry Procedure Explained

Explains the autotest retry process and conditions that can stop it.

Troubleshooting Common Issues

A guide to diagnose and resolve common operational problems and issues.

Spare Parts and Maintenance Procedures

General Maintenance Guidelines

General guidelines and safety precautions for performing maintenance.

Routine Maintenance Operations

Details on routine maintenance tasks for humidifiers.

Cylinder-Boiler Maintenance Procedures

Procedures for maintaining the cylinder-boiler, including cleaning.

Boiler Heater Electrical Connection Diagrams

Wiring diagrams for connecting boiler heaters for various models.

Wiring Diagrams for Humidifier Models

UR002-UR004 Single-Phase 208V Wiring

Electrical wiring diagram for UR002-UR004 models at 208V.

UR002-UR004 Single-Phase 230V Wiring

Electrical wiring diagram for UR002-UR004 models at 230V.

Advanced Humidifier Functions

Steam Production Regulation Principles

Different modes of steam production regulation (ON/OFF, slave, independent).

Related product manuals