stage and stays on throughout the defrost procedure, until the end of the dripping phase. The heater can
be activated by selecting a digital output with par. DOP.
Note: the heater must be protected against overheating (e.g. thermal protector).
Code Description Def Min Max UOM User
User
terminal
DOP Assign drain heater digital output - see DOA 0 0 4 - M NO
Anti-sweat heater (par. DOQ)
Selection of the digital output for demisting the glass (control with fixed activation, see the paragraph
about "Anti-sweat heaters").
Code Description Def Min Max UOM User
User
terminal
DOQ Assign anti-sweat heater digital output - see DOA 0 0 4 - S NO
50|5. Functions
MPXone +0300086EN rel. 1.0– 04.09.2018
To Next Page
Loading...