6. Parameter table
Below is the table of the parameters that can be displayed on the terminal or can be modified using the
commissioning software or APPLICA app.
The APPLICA app and commissioning tools for MPXone feature three predefined parameter access levels:
User (U), Service (S) and Manufacturer (M).
The default passwords to access the Service and Manufacturer parameters from the APPLICA MPXone app
are 022 and 044 respectively. The Manufacturer level password also allows access to the Service
parameters, and the level S password also allows access to the User parameters.
Par. Description Def. UOM Min Max U
PDM Manufacturer password 044 - 0 999 S
PDS Service password 022 - 0 999 S
PDU User password - - 0 999 U
Note: the read-only parameters are not visible from the Applica app using NFC, as NFC memory
cannot be overwritten frequently.
The MPXone parameters can be reset to the default values by using the procedure described in chapter
"installation".
Important: the operation to reset the default values is not reversible, unless a user recipe has been
previously saved for loading using the commissioning software/Applica app, see the paragraph on
recipes.
84|6. Parameter table
MPXone +0300086EN rel. 1.0– 04.09.2018
To Next Page
Loading...