To Next PageTo Next Page
Need help?Do you have a question about the Carel PCOS00KXN0 and is the answer not in the manual?
General| Power supply | 24 Vac/dc |
|---|---|
| Digital inputs | 4 |
| Analogue inputs | 4 |
| Digital outputs | 4 |
| Analogue outputs | 2 |
| Serial ports | 1 RS485 |
| BMS protocol | Modbus RTU |
| Protection degree | IP20 |
| Input voltage | 24 VAC/VDC ±10% |
| Storage temperature | -20°C to +70°C |
EU directive on WEEE disposal and product marking for separate collection and disposal.
Overview of the KNX technological standard and its approval as a European and international standard.
Details the KNX card as a gateway between KNX/EIB and Modbus RTU protocols.
Identifies the specific model number for the KNX serial card.
Instructions for installing the KNX serial card on pCO and c.pCO controllers.
Instructions for installing the KNX serial card on e-drofan controllers.
Details KNX TP1 9.6 kbits/s system mode, bus power supply, and configuration tools like ETS5.
Explains the card's role as a Modbus RTU master and supported function codes.
Configures Modbus communication parameters like address and baud rate, and KNX parameters.
Associates Modbus parameters with KNX datapoints and configures their properties.
Defines mapping tables for type 16.xxx KNX character string parameters.
Describes the procedure for assigning a unique address to the KNX card using ETS5.
Explains how to download the project configuration to the KNX card via ETS5.
Configures pCO controllers for Modbus Slave protocol and exports .2cf files for KNX card integration.
Manages Modbus Slave configuration for c.pCO controllers using c.design tool.
Sets up e-drofan controllers with specific Modbus parameters for KNX card communication.
Lists detailed technical parameters of the KNX serial card, including power, bus, and environmental specs.
