12
+030220575 - 1.1 - 04.12.2014
ENG
If a unit has been wrongly associated as a device featuring the Smooth lines yet does not actually feature
such function , PVPRO will fail to acquire the operating conditions from this device and will indicate it as N/A.
As modifying the suction pressure set point may aff ect control of the line, and PVPRO does not know the
unit’s operating conditions, the plug-in will reset the set point to the minimum value.
These two particular scenarios are illustrated in Figure 2.f.
Y N/A
yellow
orange
O
red
R
if an utility is market as N/A, it means
it doesn’t feature the Smooth line
functionality and any setpoint
increment will be reset.
Fig. 2.f
2.5 Dashboard: monitoring view (with Smooth lines)
In the “Details” tab, users can have a detailed overview of unit status. There is a summary of the settings, both
relating to PVPRO and to pRack, and the value of the working set point, with some historical samples.
At the bottom of the page, a table shows the count of units for each colour, divided between online and
offl ine.
STEP 2
To Next Page
Loading...
